Følg

VIP Energy

vip_icon.png

Vip Energy Export exports your Revit project to the energy calculation program Vip Energy.

The function exports to a .vut-file, which may be opened by other applications as well and allows you to verify the information before exporting, adjust the information as well as add more information on special parameters.

 

 

vip_buttons.png

Vip Energy Export has two buttons:

Export to VUT file, which is the main entrance to the function and handles the export.

Create Parameters, which creates all shared parameters the function requires - these are created when you run the export function, but you have the choice to create them separetely.

Export to a VUT file

 

 

The first ribbon of the export window is a summary of all elements, grouped by category and orientation.

Please note that orientation is based on the angle to true north in your Revit project - so make sure it's correct.

vip_ribbon1.png

The second ribbon is grouped by type and this is where you're able to adjust the orientation and the areas of your elements.

The changes you make here are saved to the project, in various places:

Export determines if the elements are exported at all, it's a yes/no instance parameter on all the categories below.

Orientation is saved to an instance parameter, CQVIPOrientation.

AreaAdjust is saved to two different parameters, depending on category:
Flors, Roofs, Foundations and Walls save their adjusted areas to an instance parameter, CQVIPAreaAjust.
Doors and Windows save to a type parameter, CQVIPTypeAreaAdjust.

 

The other parameters exported by the function, such as absortion, deltau etc are mainly type parameters although some exceptions could exist on floors, roofs, walls.

 

vip_ribbon2.png 

Finally, after clicking Export and saving the file somewhere you will be presented with a report on which elements were exported.

 

vip_complete.png

Create Parameters

 

This is the result of using the Create Parameters button.

Again, these are created when you run the export function, but you have the choice to create them separetely.

Please note that these parameters are shared parameters and are as such based on a text file - if you are using an older project the parameter GUID might be different.
To check, run the Create Parameters and afterwards verify that you have not recieved double parameters.

 

vip_parameters.png
Var denne artikkelen nyttig?
0 av 0 syntes dette var nyttig
Har du flere spørsmål? Send oss en henvendelse

0 Kommentarer

logg på hvis du vil legge inn en kommentar.
Levert av Zendesk